Utilities Data

This tab displays a grid with the two utilities supported for data entry: Electricity and Heat and Steam. To display data on the Utilities page, from the Sites drop-down menu, select a site. The two utilities display in the grid. If the site is only assigned one utility, that single utility displays in the grid. If no utilities are assigned to the site, the grid is blank. See Sites. Once you select a site, the country and state/city assigned to the site display above the grid.

If a supplier has been changed on the Sites page, preparers can enter and update data for both suppliers if they did not migrate all data to the new supplier.

Utilities Data Entry

To enter data for utilities, complete the following steps:

  1. Select a utility from the grid and then click the New button to add an entry for that utility.

  2. Enter all utility data in the slide-out.

    1. The Unit Type drop-down menu defaults to Energy. No selection is needed.

    2. From the Unit drop-down menu, select a unit.

    3. In the Value field, enter your value for the utility. The value must be numeric. You cannot enter a value exceeding 1019-1. Converted values also cannot exceed this number

      NOTE: The Target Unit and Converted Value fields cannot be edited. Once you save the entry, these values will display in the corresponding column grids.

    4. Add an attachment or preparer comment if needed. If a preparer comment is required, the entry cannot be saved until the comment is added. See Attachments and Comments

       

      The utilities data entry pane with unit and value fields completed.

  3. Click the Save button.

Utilities Data Audit

The Audit tab enables you to view all changes made to the selected entry. The tab displays all historical entries made, the user who made the entry, and the timestamp for the entry. The grid lists entries from newest to oldest.